Amplifier
An amplifier uses a small input signal to create a large output signal, while minimizing distortion of the waveform. Amplifiers are used for both electrical and optical signals.
Working of an Amplifier
Modern amplifiers use solid-state electronics, although some are still made with vacuum tubes. A basic amplifier can be made with transistors, while complex amplifiers use other components, like op-amps, for feedback correction. To reduce the electrical noise, most amplifiers use toroidal transformers for their power supply.
Features of an Amplifier
The important features of an amplifier are its gain, linearity, noise and dynamic range.
- Gain is a measure of an amplifier's power, the ratio of input to output power.
- Linearity is a measure of how well the output signal stays proportional to the input signal.
- Noise is the amount of static (unwanted interference) added to the input signal by the amplifier.
- Dynamicrange is the useful part of the output signal, between the noise and distortion levels.
Amplifier Stages
A typical audio setup will have a power amplifier and usually a preamplifier before it. There may also be an equalizer after the power amplifier. These may be in separate cases, or bundled together with a receiver in one big case. The preamplifier takes the weak signal from an input device, usually a microphone or turntable, and increases its voltage level so that the power amplifier can use it. Some preamplifiers merely switch inputs without changing the signal. The power amplifier increases the current of the signal so that it can drive the speakers. If the signal is amplified too much, it becomes distorted and it may need to be filtered through an equalizer before going to the speakers.
Hi-Fi Amplifier
Hi-Fi is short term for high fidelity. It is a standard for audio equipment that aims for perfect frequency response and zero signal noise, although this is never achieved in practice. This term is used to represent the very best in audio equipment, but these days, even a sub-standard equipment is labeled hi-fi.
|
|
Comments (1)
Leave a Reply
- Signal to Noise Ratio
The Signal to Noise Ratio is a ratio of desired signal to undesired signal (noise) in the average power level of a transmission. The signal is what you are measuring that is the result of the presence of your analyte. Noise is extraneous information that can interfere with or alter the signal. It can not [...]...
- Filters
In electronics, a filter is a group of components in a circuit that performs signal processing. They are made from basic components such as resistors, inductors, and capacitors. They also include microprocessors in the case of digital filters. Parts of the input signal may either be blocked or have their frequency and amplitude modified depending [...]...
- Pulse Width Modulation
Pulse Width Modulation, abbreviated as PWM, is a method of transmitting information on a series of pulses. The data that is being transmitted is encoded on the width of these pulses to control the amount of power being sent to a load. In other words, pulse width modulation is a modulation technique for generating variable [...]...
- Oscillator
An oscillator is a circuit that creates a waveform output from a direct current input. The two main types of oscillator are harmonic and relaxation. The harmonic oscillators have smooth curved waveforms, while relaxation oscillators have waveforms with sharp changes. How Oscillators Work A basic oscillator is a capacitor and inductor connected together. As the [...]...
- How to Measure Signal Quality
Most people usually look to Signal to Noise Ratio to measure the signal quality of either audio or video communications. Signal to noise ratio is usually written either S/N or SNR. Most of the time the signal to noise ratio is measured in decibels. A decibel is a measure of power or loudness. Not to [...]...
its good sir, thank you for giving the information .Sir please update and add more detail its my request please sir