• Main Menu
  • Default Passwords for Belkin Routers


    By default, all Belkin routers’ default username and password is admin (username) while “blank” (leave it blank) for the password. You need to properly connect the router to your modem and PC before you can access the router using a web browser (IE, Firefox, Chrome, etc.).  To access the router’s GUI, all you need to do is open your browser and type http://192.168.2.1 in the address bar. You can also Go to Start, then access Run, and type (http://192.168.2.1) then hit enter. You will be prompted to enter a username and a password. Use admin for the username then leave the password field ‘blank’ then hit login or just click on enter. If you already configured the router and forget the password that you nominated, you should reset your Belkin router.

    Warning: Resetting the router will erase all its settings and configurations and will set your router to its default settings.

    How to Change Belkin Default Password

    It’s essential that you reset your Belkin Wireless Router’s password as other users can easily access your router wirelessly and change its configuration to their liking. It’s easy to change the router’s default password. To do so, open a web browser then type (http://192.168.2.1) in the address bar, then in the login page, use the default username and password then click the login button. Look for the “System Settings” option in the Utilities Menu (bottom left corner). Click on it, then you will be be asked to enter the current password, new password, confirm new password. Just enter your desired password in the new password and confirm new password field.

    What if you cannot login using the default Username and Password

    If you can’t login using the default username and password, it simply means that the Belkin password has been changed. Don’t worry because you can easily reset the router to put it back to its default settings so you would be able to access the router’s configuration screen again using the default username and password. To perform a hard reset on Belkin, all you need is to locate the small “reset” button (usually at the back of the router). Make sure that the router is on, and the Ethernet cable that connects to the modem is unplugged. You can use a pin, paper clip, or a toothpick to press and hold the reset button for about 10 seconds. Wait for a few minutes or up until the router has rebooted.

    Leave a Reply to tech_faq Cancel reply

    Your email address will not be published. Required fields are marked *

    2 comments
    Networking
    172 queries in 0.649 seconds.