• Main Menu
  • Physical Layer


    The Physical Layer is the lowest layer in the OSI (Open Systems Interconnection) Model of computer networking and is used to transfer electrical signals that represent data from one place to another. While the Physical Layer does not represent data itself, it does provide a means for that data to move. Essentially, the Physical Layer represents the hardware of a computer network and consists of everything from the circuit boards and wires to the storage devices and media readers.

     

    How The Physical Layer Works

    The Physical Layer consists of different types of metal, plastic, and glass that are assembled in a way that allows electricity, light, and other forms of energy to be transferred from one location to another. Although the Data Link Layer, Network Layer, and Transport Layer are responsible for encoding data, the Physical Layer is responsible for transferring the data to where it needs to go. When a computer has encoded data that needs to be sent to another device, it uses the Physical Layer to transfer electrical signals or wireless radio waves to that device by either induction (a signal jumps from one wire to another) or propagation (a signal expands in all directions).

     

    Applications

    The Physical Layer is one of the most commonly used layers in the OSI Model and can be seen by the user at all times. Every wire, circuit board, modem, router, flash drive, hard drive, monitor, or antenna that a user interacts with while using a computer is a part of the Physical Layer.

    Leave a Reply to sunny Cancel reply

    Your email address will not be published. Required fields are marked *

    9 comments
    1. Doctor. Man, Ph.D

      16 May, 2013 at 12:18 pm

      hello, I am Doctor Do-nothing-but-copy-work, this explanation is very helpful.

      Reply
    2. PC

      18 October, 2011 at 1:58 pm

      I have an assigment to submit very soon and it ask to make a case for adding another layer to the OSI model. In your response, state why this layer may be necessary.

      Reply
    3. pooja dubey

      19 August, 2011 at 1:49 am

      how can a physical layer be briefly explained???

      Reply
    4. vikram(patna)

      29 May, 2011 at 11:23 am

      what is difference b/w mac sub layer and llc sub layer

      Reply
    5. manu

      23 March, 2011 at 3:03 pm

      can any one say how actually a data is transmitted from one layer to another between two hosts

      Reply
      • JEEVA

        27 December, 2011 at 8:38 am

        TRANSMITION OCCUR ONLY THE LAYER IS CONNECTED

        Reply
    6. sunny

      15 February, 2011 at 5:55 pm

      what is the diffrence between upper  4 layers and lower 3 layers of osi model?
      eg: upper 4 layers use peer to peer connection and lower  layes used conection-oriented why?

      Reply
      • Will.Spencer

        15 February, 2011 at 6:05 pm

        That is definitely not a difference between the upper four layers and the lower three layers.

        The lower three layers are the media layers; the upper four layers are the host layers. In theory, this means that the lower three layers have more to do with the network and the upper four layers have more to do with the host. However, this distinction is purely arbitrary.

        Reply
        • kannan

          27 February, 2011 at 6:37 pm

          Yes you absolutely correct

          Reply
    Networking
    178 queries in 0.736 seconds.