• Main Menu
  • Trickle Charging


    Trickle charging, also called float charging, is the replacement of charge lost through self-discharge. Trickle chargers work at a lower rate than quick chargers, and are used to keep a battery at full charge, not to charge it from empty. Some battery chargers use electronics to control both quick and trickle charge modes, allowing them to change modes once a battery is fully charged.

    Self-Discharge

    All batteries lose some of their charge over time without any connection between the contacts. The rate of self-discharge depends on the type of battery and other factors such as temperature. For most unused batteries, between twenty and thirty percent of the total charge is lost per month. However, lithium batteries have a self-discharge rate of less than five percent, making them ideal for long term storage.

    Charging Differences

    Quick chargers operate at a rate of more than one tenth of the battery's capacity, while trickle chargers typically have a rate one hundred times slower. Trickle chargers use a voltage that is just over the battery terminal voltage, lower than the voltage used by quick chargers.

    Overcharging

    A quick charger should not be used to maintain the battery at fully charge because it would overcharge the battery and cause damage from excess heat. Trickle chargers operate at a rate that doesn't exceed the self-discharge rate, making it difficult to overcharge a battery with one.

    Leave a Reply to Aidan Cancel reply

    Your email address will not be published. Required fields are marked *

    2 comments
    1. Aidan

      17 January, 2011 at 1:11 pm

      1. How does floating charge work
      2. The circuit diagram for the floating charging

      Reply
      • memenode

        21 January, 2011 at 1:00 pm

        Will this help?

        Reply
    Electronics
    176 queries in 0.819 seconds.