• Main Menu
  • BJT Transistors


    Basic diodes are constructed from two semiconductor materials, germanium or silicon, to create a basic PN-junction. When two single diodes are connected to each other back-to-back, two PN-junctions that are connected in series are created. They share a common N or P terminal, which forms the basis of a BJT or Bipolar Junction Transistor. The BJT is a three layer, three terminal, and two junction device. BJTs are normally used in discrete circuit design as well as high-demand analog circuits such as RFs for wireless systems. They have also been combined with MOSFETs to create hybrid circuits.

    What is a Transistor?

    A transistor is an active three terminal device that is made up of different semiconductor materials that act as either conductors or insulators through the application of small signal voltage. Its ability to switch between these two states allows it to act as a switch or amplifier. Bipolar Junction Transistors can operate in three different regions: the active region where the device acts as an amplifier, the saturation region where the transistor is fully on and acts as a switch, and the cut-off region where the device is fully off and acts as a switch.

    What are BJTs?

    A BJT (Bipolar Junction Transistor) consists of two PN-junctions that produce three terminals that connect with each one given a unique name to distinguish it from the other two. The labels used on BJTs are Base (B), Emitter (E), and Collector (C ). BJTs regulate current in proportion to the amount of biasing voltage applied to their base terminal and act as a controlled switch as a result.

    BJT Configurations

    There are three ways to connect a BJT in an electronic circuit since it is a three terminal device. Each connection method responds to a circuit’s input signal in a different way. The three configurations are: 1) The Common Base, which has no current gain but has voltage gain, 2) The Common Emitter, which has both current and voltage gain, and 3) The Common Collector, which has current but no voltage gain.

    Leave a Reply to memenode Cancel reply

    Your email address will not be published. Required fields are marked *

    2 comments
    1. siri

      16 April, 2011 at 9:47 am

      when two similar diodes connected in parallel, what happens?

      Reply
      • memenode

        17 April, 2011 at 12:58 pm

        If they’re connected in the same direction they share the current. If in the opposite direction the current passes through them with a slight voltage reduction.

        Reply
    Electronic Components
    177 queries in 0.592 seconds.